PRODUCT FAULT OVERRIDE 
Some faults are disabled when Product Fault Override is enabled

Faults disabled when this mode is active are listed below:
1) No Product - Fault will not occur when product is not detected at infeed.
2) Down Product Faults - Fault will not occur when down product is detected.
3) Hopper Not Filling - Fault will not occur for cartons failing to fill hopper.
4) Top Deformed Product - Fault will not occur when a top deformed or missing carton is detected at the feed area
5) Bottom Deformed Product - Fault will not occur when a bottom deformed or missing carton is detected at the feed area
6) Open Flap - Fault will not occur is an open flap is detected near the exit of the machine.
7) E-Stop Check Pack - Fault will not occur for "Pack Check" after an Emergency Stop occurs.
8) Glue Tank Fault - Fault will not occur for glue tank faults.
9) Glue Tank Not Ready - Fault will not occur when the glue tank is not ready for operation.
10) Glue Tank Set Back Mode - Fault will not occur for glue tank in set back mode.